Home » Electronics and Communication Engineering » Matching Questions

Match the following: List I (Types of transmission structure) List II (Modes of propagation) A. Strip line 1. Quasi TEM B. Hollow rectangular waveguide 2. Pure TEM C. Microstrip 3. TE/TM D. Corrugated waveguide 4. Hybrid

A-2, B-1, C-3, D-4
A-4, B-1, C-3, D-2
A-2, B-3, C-1, D-4
A-4, B-3, C-1, D-2

Correct Answer: A-2, B-3, C-1, D-4

← Previous Question Next Question→

More Questions from Matching Questions

Match the following: List I f(t) List II F (s) A. cos ωt 1. B. sin ωt 2. C. cosh ωt 3. D. sinh ωt 4.
Match the following: List I (Network parameter) List II (Measured under open-circuit conditions) A. Z11 1. B. A 2. C. C 3. D. Z22 4.
Match the following: List I (μP) List II (Number of bits in register) A. 8085 1. 32 bit B. 8086 2. 16 bit C. 68000 3. 8/16 bit
Match the following: List I (Circuit) List II (Characteristics) A. Darlington pair 1. uses pnp and npn transistors used as power amplifier B. CB amplifier 2. Voltage gain nearly 1 and high input impedance C. Cascade amplifier 3. low input impedance used for high frequency isolation
Match the following: List I List II A. Ring modulator 1. Clock recovery B. VCO 2. Demodulation of FM C. Foster Seeley discriminator 3. Frequency conversion D. Mixer 4. Summing of two points 5. Generation of FM 6. Generation of DSB-SC
Match the following: List I List II A. 1. B. 2. C. 3. D. 4.
Match the following: List I List II A. RC coupled amplifier 1. Very low drift B. Tuned amplifier 2. Flat frequency response from zero frequency onwards C. Chopper stabilized amplifier 3. Flat frequency response with upper and lower cut off frequency D. DC amplifier 4. Peak in gain frequency response
Match the following: List I (Operator in C) List II (Priority of Operation) A. ! 1. 1 B. < > 2. 2 C. ∗ 3. 3 D. = 4. 4
Match the following: List I List II A. Output of signal generator 1. Modulated B. Error signal from a synchro 2. Digital C. Output of a JK flip flop 3. Analog D. Signal received by radar 4. Stoichastic
Match the following: List I List II A. shift Register 1. Frequency division B. Counter 2. Addressing in memory chips C. Decoder 3. Serial to parallel Data conversion

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion