Curioustab

Home » Digital Electronics » Flip-Flops

Latches constructed with NOR and NAND gates tend to remain in the latched condition due to which configuration feature?

cross coupling
gate impedance
low input voltages
asynchronous operation

Correct Answer: cross coupling

← Previous Question Next Question→

More Questions from Flip-Flops

A J-K flip-flop is in a "no change" condition when ________.
How can the cross-coupled NAND flip-flop be made to have active-HIGH S-R inputs?
On a master-slave flip-flop, when is the master enabled?
Why are the S and R inputs of a gated flip-flop said to be synchronous?
The circuit given below fails to function; the inputs are checked with a logic probe and the following indications are obtained: CLK, J1, J2, J3, K1, K2, and K3 are pulsing. Q and are HIGH. and PRE are LOW. What could be causing the problem?
An RC circuit used in a 74122 retriggerable one-shot has an REXT of 100 kΩ and a CEXT of 0.005 µF. The pulse width is ________.
In VHDL, how is each instance of a component addressed?
What is the hold condition of a flip-flop?
An RC circuit used in a nonretriggerable 74121 one-shot has an REXT of 49 kΩ and a CEXT of 0.2 µF. The pulse width (tW) is approximately ________.
In a 555 timer, three 5 kΩ resistors provide a trigger level of ________.

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion