Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Home
»
Mechanical Engineering
»
Production Engineering
The lip angle is the angle
between the tool face and the ground end surface of flank
made by the face of the tool and the plane parallel to the base of the cutting tool
between the face of the tool and a line tangent to the machined surface at the cutting point
none of the above
Correct Answer:
between the tool face and the ground end surface of flank
← Previous Question
Next Question→
More Questions from
Production Engineering
Crater wear is mainly due to the phenomenon known as
Flank wear depends upon the
The carbide tools operating at very low cutting speeds (below 30 m/min)
The abrasive recommended for grinding materials of low tensile strength is
The addition of lead, sulphur and phosphorus to low carbon steels, help to
The cutting fluid mostly used for machining steel is
With the same tool life, the maximum material per minute is removed by
In which of the following machine, the work is usually rotated while the drill is fed into work?
The relation between the tool life (T) in minutes and cutting speed (V) in m/min is (where n = An exponent, which depends upon the tool and workpiece, and C = A constant)
The operation of producing grooves around the periphery of a cylindrical or conical workpiece is called
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments