Curioustab

Home » Civil Engineering » Highway Engineering

On earth roads, the camber should preferably be

1 in 20 to 1 in 24
1 in 30 to 1 in 48
1 in 15 to 1 in 20
1 in 10 to 1 in 15
1 in 10 to 1 in 12

Correct Answer: 1 in 20 to 1 in 24

← Previous Question Next Question→

More Questions from Highway Engineering

To prevent compressive stresses in a rigid concrete pavement, the joint prvoided, is
Alignment of highways in hilly regions, is decided on
Pick up the incorrect statement from the following:
Setting out of Lemniscate transition curves, is done with
Super-elevation on roads in snow bound areas, should generally not exceed
If L is the length of the transition curves provided on either side of a circular curve of radius R, the maximum angle of deflection with tangent for the junctions of the transition curve and circular curve, is
Indian Road Congress (I.R.C.) was founded and constituted with its head quarters at New Delhi, in
If the width of a pavement slab is 7.5 m, thickness 20 cm and working stress 1400 kg/cm2, spacing of 10 mm tie bars for the longitudinal joint, is
If the rate of change of the super-elevation along a curved portion of a 7 metre wide road is 1 in 150 and the maximum super-elevation allowed is 1 in 15, the maximum length of the transition curve to be provided at either end, is
Excessive camber on pavements may cause

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion