Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Home
»
Mechanical Engineering
»
Production Engineering
The type of tool used on lathe, shaper and planer is
single point cutting tool
two point cutting tool
three point cutting tool
multi-point cutting tool
Correct Answer:
single point cutting tool
← Previous Question
Next Question→
More Questions from
Production Engineering
The hardness of a grinding wheel is specified by
In a shaper, the length of stroke is increased by
The rear teeth of a broach
Thread grinding requires work speed from
An important geometrical quantity in the cutting of metals which can be used as a criterion for machinability of metals is
As the cutting speed increases, tool life decreases.
Crater wear is predominant in
The top and sides of the table of a shaper usually have
The swing diameter over the bed is __________ the height of the centre measured from the bed of the lathe.
The abrasive recommended for grinding materials of high tensile strength is
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments