Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Home
»
Mechanical Engineering
»
Production Engineering
In oblique cutting system, the maximum chip thickness
occurs at the middle
may not occur at the middle
depends upon the material of the tool
depends upon the geometry of the tool
Correct Answer:
may not occur at the middle
← Previous Question
Next Question→
More Questions from
Production Engineering
The guideways are of
High speed steel cutting tools operate at cutting speeds __________ than carbon steel tools.
The material which on machining produces chips with built up edge is
The continuous chips are in the form of long coils having the same thickness throughout.
The chisel edge angle of a drill is usually 120° to 135°.
The main purpose of a boring operation, as compared to drilling, is to
In down milling, the thickness of chip is
The cutting speed for drilling copper with high speed steel drills varies from
Climb milling is chosen while machining because
The high cutting speed and large rake angle of the tool will result in the formation of
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments