Curioustab

Home » Electronics and Communication Engineering » Analog Electronics

To prevent a DC return between source and load, it is necessary to use

resistor between source and load
inductor between source and load
capacitor between source and load
either (a) or (b)

Correct Answer: capacitor between source and load

Explanation:

Capacitor offers infinite impedance to DC.

← Previous Question Next Question→

More Questions from Analog Electronics

The self bias provides
The quiescent collector current IC, and collector to emitter voltage VCE in a CE connection are the values when
Figure shows the self bias circuit for CE amplifier and its equivalent circuit. VBB and RB respectively are
In a circuit of figure, Vs = 10 cos(ωt) power drawn by the 2Ω resistor is 4 watts. The power factor is
In a BJT circuit a pnp transistor is replaced by npn transistor. To analyse the new circuit
An amplifier has a large ac input signal. The clipping occurs on both the peaks. The output voltage will be nearly a
If an amplifier with gain of - 1000 and feedback factor β = - 0.1 had a gain change of 20% due to temperature, the change in gain of the feedback amplifier would be
In the op-amp circuit of figure, V0 =
To protect the diodes in a rectifier and capacitor input filter circuit it is necessary to use
In figure v1 = 8 V and v2 = 4 V. Which diode will conduct?

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion