Curioustab

Home » Electronics and Communication Engineering » Analog Electronics

An amplifier has a large ac input signal. The clipping occurs on both the peaks. The output voltage will be nearly a

sine wave
square wave
triangular wave
(a) or (c)

Correct Answer: square wave

Explanation:

When a sinusoidal voltage is clipped on both sides it resembles a square wave.

← Previous Question Next Question→

More Questions from Analog Electronics

If an amplifier with gain of - 1000 and feedback factor β = - 0.1 had a gain change of 20% due to temperature, the change in gain of the feedback amplifier would be
In the op-amp circuit of figure, V0 =
To protect the diodes in a rectifier and capacitor input filter circuit it is necessary to use
In figure v1 = 8 V and v2 = 4 V. Which diode will conduct?
In figure ID = 4 mA. Then VS =
A half wave diode rectifier has a capacitance input filter. If input voltage is Vm sin ωt, PIV is
The efficiency of a full wave rectifier using centre tapped transformer is twice that in full wave bridge rectifier.
The transistor of following figure in Si diode with a base current of 40 μA and ICBO = 0, if VBB = 6V, RE = 2 kΩ and β = 90, IBQ = 20 μA then RB =
If the input to the ideal comparator shown in the figure is a sinusoidal signal of 8 V (peak to peak) without any DC component, then the output of the comparator has a duty cycle of
For a system to work, as oscillator the total phase shift of the loop gain must be equal to

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion