Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Home
»
Mechanical Engineering
»
Production Engineering
In oblique cutting system, the cutting edge of the tool
may clear the width of the workpiece
may or may not clear the width of the workpiece
may not clear the width of the workpiece
should always clear the width of the workpiece
Correct Answer:
may not clear the width of the workpiece
← Previous Question
Next Question→
More Questions from
Production Engineering
Flank wear is due to the abrasive action of hard mis-constituents including debris from built up edge as the work material rubs the work surface.
In gear hobbing
A numerical method of identification of tool is known as tool signature.
The chuck preferred for quick setting and accurate centering of a job is
The dressing and truing of grinding wheel are done with the same tools but not for the same purpose.
The tail stock set over method of taper turning is preferred for
The effect of setting a boring tool above centre height leads to
The tool life __________ as the cutting speed increases.
Chemical milling operation is performed
The thrust force will increase with the increase in
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments