Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Home
»
Mechanical Engineering
»
Production Engineering
For harder alloy steel, the point angle of the drill is kept
equal to 118°
less than 118°
more than 118°
any one of these
Correct Answer:
more than 118°
← Previous Question
Next Question→
More Questions from
Production Engineering
In order to achieve a specific surface finish in single point turning, the most important factor to be controlled is
A better machinable metal is one which gives
Which of the following statement is correct about hot machining?
Ceramic cutting tools are
Spot facing is an operation of smoothing and squaring the surface around a hole.
The tail stock and the carriage of a lathe may be guided on same or different guideway.
In __________ operation, the chip thickness is minimum at the beginning of the cut and it reaches to the maximum when the cut terminates.
In centreless grinders, the regulating wheel is inclined at
The average cutting speed for turning mild steel with a high speed steel tool is
A drill bit of 20 mm diameter rotating at 500 r.p.m. with a feed rate of 0.2 mm/revolution is used to drill a through-hole in a mild steel plate 20 mm thickness. The depth of cut in this drilling operation is
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments