Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Home
»
Mechanical Engineering
»
Production Engineering
Hard and tough materials like cast iron should be turned at
slow speed
high speed
any speed
certain specific speed
Correct Answer:
slow speed
← Previous Question
Next Question→
More Questions from
Production Engineering
Tumbler gears in lathe are used to
In the relation VTn = C, the value of n for high speed steel tools varies from 0.25 to 0.40.
Negative rakes are used for
In oblique cutting system, the cutting edge of the tool
Flank wear is due to the abrasive action of hard mis-constituents including debris from built up edge as the work material rubs the work surface.
In gear hobbing
A numerical method of identification of tool is known as tool signature.
The chuck preferred for quick setting and accurate centering of a job is
The dressing and truing of grinding wheel are done with the same tools but not for the same purpose.
The tail stock set over method of taper turning is preferred for
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments