Curioustab

Home » Electronics and Communication Engineering » Measurements and Instrumentation

A voltmeter using thermocouples measures

rms value
peak value
average value
peak to peak value

Correct Answer: rms value

Explanation:

Since the thermocouple is based on heating effect, rms value is measured.

← Previous Question Next Question→

More Questions from Measurements and Instrumentation

Which of the following statement is correct for two wattmeters method of power measurement in 3 phase circuit?
In a CRO which of the following is not a part of electron gun
The coil of a moving iron instrument has a resistance of 500 Ω and an inductance of 1 H. It reads 250 V when a 250 V dc is applied. If series resistance is 2000 Ω, its reading when fed by 250 V, 50 Hz ac will be
In a ballistic galvanometer, a charge of 100 μC gives a first swing of 25°. The charge required to cause first swing of 50° is
In a strain measuring device using a strain gauge, the output quantity is
Magnetic flux density has the dimensions
A dynamometer wattmeter is connected in ac circuit. The measured power is
A meter with a resistance of 100 Ω and a full scale deflection of current of 1 mA is to be converted into voltmeter of 0 - 5 V range. The multiplier resistance should be
A dynamometer wattmeter is connected in ac circuit. The reading will be
In figure the bridge is balanced when Z4 is

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion