Home » Electronics and Communication Engineering » Matching Questions

Match the following: List I (Network Theorems) List II (Most distinguished property of networks) A. Reciprocity 1. Impedance Matching B. Tellegen's 2. Bilateral C. Superposition 3. vk(t1)ik(t2) = 0 D. Maximum power transfer 4. Linear 5. Non-linear

A-1, B-2, C-3, D-4
A-1, B-2, C-3, D-5
A-2, B-3, C-4, D-1
A-2, B-3, C-5, D-1

Correct Answer: A-2, B-3, C-4, D-1

← Previous Question Next Question→

More Questions from Matching Questions

Match the following: List I (Symbol in Java comparison operator) List II (Meaning) A. = = 1. Greater than or equal to B. ! = 2. Equal C. > = 3. Not equal
Match the following: List I (Modulation ) List II (Modulation Index) A. DSBFC 1. μ > 1 B. DSBSC 2. μ > 0 C. SSB 3. ∞ 4. μ, any value
Match the following: List I (Microwave device) List II (Application) A. Reflex Klystron 1. Wideband amplification B. TWT 2. Very low power amplification C. Cavity Klystron 3. Low power FM generation D. Maser 4. Frequency multiplication
Match the following: List I (Microwave device) List II (Application) A. PIN diode 1. Microwave amplification B. GaAs MOSFET 2. Low noise microwave generation C. Transferred electron device 3. Electronic tuning of MW oscillator D. Varactor diode 4. Light wave detection
Match the following: List I (Set operation) List II (Set operator) A. Set equality 1. - B. Set inclusion 2. = C. Set intersection 3. < = D. Set difference 4. ∗
Match the following: List I List II A. Conductor 1. B. Semiconductor 2. C. Insulator 3.
Match the following: List I List II A. Silicon 1. Donor Impurity B. Antimony 2. Acceptor Impurity C. Gallium 3. Most Commonly used semiconductor material D. Germanium 4. Atomic number 32
Match the following: List I (Characteristic equation) List II (Degree of damping) A. s2 + 15s + 56.25 1. Undamped B. s2 + 5s + 6 2. Underdamped C. s2 + 20.25 3. Critically damped D. s2 + 4.55s + 42.25 4. Overdamped
Match the following: List I List II A. 1. v(t) = u(t + 1) B. 2. v(t) = u(t) - 2u(t - 1) + 2u(t - 2) - 2u(t - 3).... C. 3. v(t) = u(t - 1) - u(t - 3) D. 4. v(t) = δ(t - 1)
Match the following: List I List II A. lag compensation 1. Exterior of unit circle |z| = 1 B. lead compensation 2. PD control C. stability 3. Non-minimum phase D. Instability 4. Left half s plane 5. PI control

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion