Home » Electronics and Communication Engineering » Matching Questions

Match the following: List I List II A. Effective length of antenna 1. B. Capture area 2. C. Front to back ratio 3.

A-3, B-2, C-1
A-2, B-3, C-1
A-1, B-3, C-2

Correct Answer: A-2, B-3, C-1

← Previous Question Next Question→

More Questions from Matching Questions

Match the following: List I List II A. FM 1. slope-overload B. DM 2. μ law C. PSK 3. Envelope detector D. PCM 4. Capture effect 5. Hilbert transform 6. Matched filter.
Match the following: List I (Power device) List II (Max. frequency) A. Power Bipolar 1. MHz B. Power MOSFET 2. 100 kHz C. SCR 3. 10 kHz D. Insulated gate bipolar transistor 4. 1 kHz
Match the following: List I List II A. Detection of a periodic signal in noise 1. Increase in band-width B. Recovery of a band limited signal from its uniformly sampled values 2. Slope over load error C. Finer quantization 3. Nyquist rate of signals D. Delta modulation 4. Cross correlation
Match the following: List I (Amplifier coupling) List II (Feature) A. RC 1. High voltage gain and impedance matching B. Inductive 2. Ability to amplify dc and low frequency signals C. Transformer 3. Minimum non-linear distortion D. Direct 4. Low collector supply voltage can be used
Match the following: List I List II A. SUS 1. B. SBS 2. C. SCS 3. D. Shockley diode 4.
Match the following: List I List II A. Sky wave 1. parasitic elements B. Antenna feed 2. delta match C. Reflector 3. long-wire antenna D. Rhombic antenna 4. ionosphere
Match the following: List I List II A. ∇ x = 0 1. irrotational vector B. ∇ . = 0 2. conservative field C. ∮ .dl = 0 3. solenoidal vector
Match the following: List I (Location of characteristics roots) List II (System characteristic) A. (- 1 + j), (- 1 - j) 1. Marginally stable B. (- 2 + j), (- 2 - j), (2, j) (- 2, j) 2. Unstable C. - j, j - 1, 1 3. Stable
Match the following: List I List II A. Digital counter 1. Measurement of harmonics B. Schering Bridge 2. Measurement of frequency C. Meggar 3. Measurement of loss angle of dielectric D. Spectrum analyser 4. Measurement of insulation resistance
Match the following: List I (Operator) List II (Description) A. & & 1. Bitwise inclusive OR B. & 2. Bitwise AND C. | | 3. Logical AND D. | 4. Logical OR

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion