Curioustab

Home » Chemical Engineering » Process Equipment and Plant Design

Power required for agitation depends upon the

height & properties of the liquid.
agitator type & speed of agitation.
size of agitator & the tank.
all (a), (b) and (c).

Correct Answer: all (a), (b) and (c).

← Previous Question Next Question→

More Questions from Process Equipment and Plant Design

Support design: when can wind load be neglected for process vessels and tanks?
Heat exchangers: for a multi-pass shell-and-tube exchanger, which statement about the log mean temperature difference (LMTD) is correct?
Dished heads: for better strength, the knuckle radius of a torispherical head should meet a minimum. The provided knuckle radius should be not less than which criterion?
In solid mechanics, the ratio of lateral strain to linear (longitudinal) strain is termed as:
In plate-and-frame filter presses used in chemical/process engineering, the frame thickness is normally within the following range (inches):
Shell-and-tube exchanger with square tube pitch: the shell-side equivalent (hydraulic) diameter De for crossflow is given by (P = pitch, d = tube outside diameter):
In liquid–solid filtration, which factors affect the filtration rate under constant-pressure operation?
Which heat exchanger type is commonly referred to as a “hairpin” exchanger in process industries?
For selecting an optimum economic pipe diameter for fluid transport, the governing criterion is based on:
Shell-and-tube heat exchanger practices: pick out the statement that is WRONG.

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion