Curioustab

Home » Civil Engineering » Strength of Materials

A member which does not regain its original shape after removed of load producing deformation is said

plastic
elastic
rigid
none of these.

Correct Answer: plastic

← Previous Question Next Question→

More Questions from Strength of Materials

The point of contraflexture occurs in
The ratio of the tensile stress developed in the wall of a boiler in the circumferential direction to the tensile stress in the axial direction, is
At either end of a plane frame, maximum number of possible bending moments, are
A steel rod of 2 cm diameter and 5 metres long is subjected to an axial pull of 3000 kg. If E = 2.1 x 106, the elongation of the rod will be
For a given material, if E, C, K and m are Young's modulus, shearing modulus, bulk modulus and poisson ratio, the following relation does not hold good
In a shaft rotated by a couple, the shear force varies
The force in the member DE of the truss shown in below figure will be
The force in BD of the truss shown in below figure is :
Along the neutral axis of a simply supported beam
The section modulus of a rectangular light beam 25 metres long is 12.500 cm3. The beam is simply supported at its ends and carries a longitudinal axial tensile load of 10 tonnes in addition to a point load of 4 tonnes at the centre. The maximum stress in the bottom most fibre at the mid span section, is

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion