Curioustab

Home » Civil Engineering » Strength of Materials

The force in the member DE of the truss shown in below figure will be

zero
2 W tensile
2 W compressive
4 W compressive
4 W tensile.

Correct Answer: 2 W compressive

← Previous Question Next Question→

More Questions from Strength of Materials

The force in BD of the truss shown in below figure is :
Along the neutral axis of a simply supported beam
The section modulus of a rectangular light beam 25 metres long is 12.500 cm3. The beam is simply supported at its ends and carries a longitudinal axial tensile load of 10 tonnes in addition to a point load of 4 tonnes at the centre. The maximum stress in the bottom most fibre at the mid span section, is
For a simply supported beam carrying uniformly distributed load W on it entire length L, the maximum bending moment is
For the beam shown in below figure, the maximum positive bending moment is nearly equal to negative bending moment when L1 is equal to
Shear deflection of a cantilever of length L, cross sectional area A and shear modulus G, under a concentrated load W at its free end, is
In a three hinged arch, the bending moment will be zero
The ratio of the moments of resistance of a solid circular shaft of diameter D and a hollow shaft (external diameter D and internal diameter d), is
The moment diagram for a cantilever carrying a concentrated load at its free end, will be
The stress at which extension of a material takes place more quickly as compared to the increase in load, is called

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion