logo

CuriousTab

CuriousTab

Discussion


Home Civil Engineering Strength of Materials Comments

  • Question
  • Along the principal plan subjected to maximum principal stress


  • Options
  • A. maximum shear stress acts
  • B. minimum shear stress acts
  • C. no shear stress acts
  • D. none of these.

  • Correct Answer
  • no shear stress acts 


  • Strength of Materials problems


    Search Results


    • 1. The bending moment at E for the structure shown in below figure, is

    • Options
    • A. zero
    • B. 10 Tm
    • C. 20 Tm
    • D. 40 Tm.
    • Discuss
    • 2. If the width b and depth d of a beam simply supported with a central load are interchanged, the deflection at the centre of the beam will be changed in the ratio of

    • Options
    • A. b/d
    • B. d/b
    • C. (d/b)2
    • D. (b/d)2
    • E. (b/d)3.
    • Discuss
    • 3. Strain energy of a member may be equated to

    • Options
    • A. average resistance x displacement
    • B. stress x strain x area of its cross-section
    • C. stress x strain x volume of the member
    • D. (stress)2 x volume of the member + Young's modulus E.
    • Discuss
    • 4. In a simply supported beam L with a triangular load W varying from zero at one end to the maximum value at the other end, the maximum bending moment is

    • Options
    • A.
    • B.
    • C.
    • D.
    • E.
    • Discuss
    • 5. If a member is subjected to a tensile force P, having its normal cross-section A, the resulting shear stress in an oblique plane inclined at an angle ? to its transverse plane, is

    • Options
    • A.
    • B.
    • C.
    • D.
    • E.
    • Discuss
    • 6. Rankine-Golden formula accounts for direct as well as buckling stress and is applicable to

    • Options
    • A. very long columns
    • B. long columns
    • C. short columns
    • D. intermediate columns
    • E. all the above.
    • Discuss
    • 7. When a rectangular beam is loaded longitudinally, shear develops on

    • Options
    • A. bottom fibre
    • B. top fibre
    • C. middle fibre
    • D. every-horizontal plane.
    • Discuss
    • 8. A member which does not regain its original shape after removed of load producing deformation is said

    • Options
    • A. plastic
    • B. elastic
    • C. rigid
    • D. none of these.
    • Discuss
    • 9. The point of contraflexture occurs in

    • Options
    • A. cantilever beams only
    • B. continuous beams only
    • C. over hanging beams only
    • D. all types of beams
    • E. both (a) and (b).
    • Discuss
    • 10. The ratio of the tensile stress developed in the wall of a boiler in the circumferential direction to the tensile stress in the axial direction, is

    • Options
    • A. 4
    • B. 3
    • C. 2
    • D. 1
    • Discuss


    Comments

    There are no comments.

Enter a new Comment