Curioustab

Home » Digital Electronics » Digital Design

Why would a delay gate be needed for a digital circuit?

A delay gate is never needed.
to provide for setup times
to provide for hold times
to provide for setup times and hold times

Correct Answer: to provide for setup times and hold times

← Previous Question Next Question→

More Questions from Digital Design

Why is the Schmitt trigger needed in the 60-Hz TTL-level clock pulse generator?
Look up the propagation delay from the clock to the output for the 7476. Are the HIGH-to-LOW and LOW-to-HIGH propagation delays the same?
In the automatic reset circuit for a flip-flop, how long does it take the capacitor to completely charge?
A settable flip-flop's normal starting state when power is first applied to a circuit is always the ________ state.
What is the difference between setup time and hold time?
Which of the following circuit parameters would be most likely to limit the maximum operating frequency of a flip-flop?
Is the propagation delay from the clock to the output for the 7476 the same as the delay from the set or reset to the output?
Decoupling capacitors should be tied from VCC on one device to ground on a different device.
The purpose of a pull-up resistor is to keep a terminal at a ________ level when it would normally be at a ________ level.
Why does the data sheet for the 7476 only give a minimum value for the clock pulse width (both HIGH and LOW)?

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion