Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Take Free Test
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Take Free Test
Home
»
Computer Science
»
Computer Hardware
During the fusing process, toner is:
dry pressed into the paper
electrically bonded to the paper
melted into the paper
glued to the paper
high pressure sprayed onto the paper
Correct Answer:
high pressure sprayed onto the paper
← Previous Question
Next Question→
More Questions from
Computer Hardware
How can you totally protect a PC from damage during an electrical storm?
To test for AC ripple on a PC power supply, you would set the volt/ohm meter for:
Which best describes a fragmented hard drive:
Which provides the fastest data access time?
ESD damage can be caused by:
If a computer's BIOS allows it, you can boot from a CD-ROM.
When configuring a new network interface card for installation, which of the following would be a valid I/O address?
What is the jumper setting on a SCSI device to configure it to use the fourth SCSI id? Remember, SCSI ids start with zero.
What problem can occur if a printer cable is to close to a power cable?
You are testing the resistance in Ohms of a fuse on a 5 amp system. If the fuse is good, the meter should read?
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments