Home » Civil Engineering » UPSC Civil Service Exam Questions

Two simply supported beams B1 and B2 have spans l and 2l respectively. Beam B1 has a cross-section of 1 x 1 units and beam B2 has a cross-section of 2 x 2 units. These beams are subjected to concentrated loads W each at the centre of their spans. The ratio of the maximum flexural stress in these beams is

Correct Answer: 4

← Previous Question Next Question→

More Questions from UPSC Civil Service Exam Questions

A locomotive has four pairs of driving wheels carrying an axle load of 24 x 104 N. The maximum load that can be pulled if the coefficient of friction is 1/6, is
A particle of mass 3 kg moving in a straight line decelerates uniformly from a speed of 40 m/s to 20 m/s in a distance of 300 m. Before it comes to rest, it will travel a further distance pf
A cylindrical shell made of mild steel plate of 100 cm diameter is to be subjected to an internal pressure of 10 kg/cm2. If the material yields at 2000 kg/cm2, assuming factor of safety as four and using maximum principal stress theory, thickness of the plate will be
In the force system shown in the figure, the force CA should be
Consider the following strengths of concrete : 1. Cube strength 2. Cylinder strength 3. Split-tensile strength 4. Modulus of rupture The correct sequence in decreasing order of these strengths is
The graphical condition for equilibrium of concurrent forces is that
A close-coiled helical spring with n coils, mean radius R and diameter d is subjected to an axial load W. What is the compression in the spring?
The plastic modulus of a section is 5 x 10-4m3. Its shape factor is 1.2 and the plastic moment capacity is 120 kNm. What is the value of the yield stress of the material?
The figure refers to a channel section of uniform thickness of 1 cm used as a beam with the cross-sectional dimensions shown in cm units. If the Moment of Inertia of channel Ixx be equal to 246 cm4 and C be the shear centre, then the value of e in cm is equal to
Consider the following statements : 1. An ascending gradient of 1 in 100 meets an ascending gradient of 1 in 120 to form a Valley curve. 2. A falling gradient of 1 in 25 meets a falling gradient of 1 in 50 to form a summit curve. 3. The length of summit curve is determined on the basis of head light sight distance. Which one of the statements given above is/are correct?

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion