Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Home
»
Civil Engineering
»
Steel Structure Design
When a tension member is made of four angles with a plate as a web, the allowance for holes is made as
two holes for each angle and one hole for the web
one hole for each angle and one hole for the web
one hole for each angle and two holes for the web
two holes for each angle and two holes for the web
none of these.
Correct Answer:
one hole for each angle and two holes for the web
← Previous Question
Next Question→
More Questions from
Steel Structure Design
The minimum edge distance of a rivet line connecting two or more plates, is kept equal to 37 mm plus (where t is the thickness in mm of the thinner outside plate).
If the pitch is 6 cm and rivet value is 4 tonnes, the number of rivets required for a riveted connection carrying an eccentric load of 15 tonnes at a distance of 30 cm from the centre line, is
The critical load for a column of length I hinged at both ends and having flexural rigidity El, is given by
The thickness t of a single flat lacing should not be less than
Column footing is provided
The maximum permissible slenderness ratio of a member carrying loads resulting from wind, is
The critical stress on a column for elastic buckling given by Euler's formula, is
The cross-section of a standard fillet is a triangle whose base angles are
A second horizontal stiffener is always placed at the neutral axis of the girder if the thickness of the web is less than
Pick up the correct statement from the following:
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments