Curioustab

Home » Civil Engineering » Steel Structure Design

Outstanding length of a compression member consisting of a channel, is measured as

half of the nominal width
nominal width of the section
from the edge to the first row of rivets
none of these.

Correct Answer: nominal width of the section

← Previous Question Next Question→

More Questions from Steel Structure Design

The ratio of hydrostatic stress to the volumetric strain within the elastic range, is called
In a built up section carrying a tensile force, the flanges of two channels are turned outward
Effective length of a column effectively held in position at both ends and restrained in direction at one end, is
Cold driven rivets range from
The greatest gauge of long rivets should not exceed (where d is the diameter of the holes).
Design of a riveted joint, is based on the assumption:
When the depth of a plate girder is at least n times the depth of vertical leg of the flange angles, the girder is known as deep plate girder, if n is
Pick up the correct statement from the following:
If the area of cross-section of a single angle discontinuous strut is 30 cm2 and allowable working stress corresponding to its slenderness ratio is 625 kg/cm2, the safe load carrying capacity of the member, is
The economical depth d of a web plate in which allowable bearing stress is fb, and the maximum bending moment is M, as suggested by Rawater and Clark, is

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion