Curioustab

Home » Civil Engineering » Steel Structure Design

If the depth of two column sections are equal, then the column splice is provided

with filler plates
with bearing plates
with filler and hearing plates
none of these.

Correct Answer: none of these.

← Previous Question Next Question→

More Questions from Steel Structure Design

For the steel member exposed to weather and accessible for repainting, the thickness of steel should not be less than (excepting the webs of Indian Standard rolled steel joists and channels).
Secant formula for direct stress in compression, is applicable only for slenderness ratio upto
The equivalent axial tensile load Pe, which produces an average axial tensile stress in the section equivalent to the combined stress due to axial tension P and bending M, at the extreme fibre of the section, is given by (where Z is the section modulus of the section).
When a tension member is made of four angles with a plate as a web, the allowance for holes is made as
The minimum edge distance of a rivet line connecting two or more plates, is kept equal to 37 mm plus (where t is the thickness in mm of the thinner outside plate).
If the pitch is 6 cm and rivet value is 4 tonnes, the number of rivets required for a riveted connection carrying an eccentric load of 15 tonnes at a distance of 30 cm from the centre line, is
The critical load for a column of length I hinged at both ends and having flexural rigidity El, is given by
The thickness t of a single flat lacing should not be less than
Column footing is provided
The maximum permissible slenderness ratio of a member carrying loads resulting from wind, is

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion