Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Home
»
Civil Engineering
»
Steel Structure Design
Cold driven rivets range from
6 to 10 mm in diameter
10 to 16 mm in diameter
12 to 22 mm in diameter
22 to 32 mm in diameter
none of these.
Correct Answer:
12 to 22 mm in diameter
← Previous Question
Next Question→
More Questions from
Steel Structure Design
The greatest gauge of long rivets should not exceed (where d is the diameter of the holes).
Design of a riveted joint, is based on the assumption:
When the depth of a plate girder is at least n times the depth of vertical leg of the flange angles, the girder is known as deep plate girder, if n is
Pick up the correct statement from the following:
If the area of cross-section of a single angle discontinuous strut is 30 cm2 and allowable working stress corresponding to its slenderness ratio is 625 kg/cm2, the safe load carrying capacity of the member, is
The economical depth d of a web plate in which allowable bearing stress is fb, and the maximum bending moment is M, as suggested by Rawater and Clark, is
Under a concentrated load, bearing stress fb in a beam, is given by (where b is the length of the bearing plate and h is the depth of the root of the fillet).
Tacking rivets in tension members, are provided at a pitch in line not exceeding
With usual notations of the letters, the shear stress fs at any point of the cross-section is given by
Rise of a Jack arch is kept about
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments