Curioustab

Home » Chemical Engineering » Process Equipment and Plant Design

Power required for agitation depends upon the

height & properties of the liquid.
agitator type & speed of agitation.
size of agitator & the tank.
all (a), (b) and (c).

Correct Answer: all (a), (b) and (c).

← Previous Question Next Question→

More Questions from Process Equipment and Plant Design

Wind load consideration in the design of a support can be neglected, when the vessel is
Log mean temperature difference in case of multi-pass shell and tube heat exchanger is always
Practical dividing line between a ductile and brittle materials is suggested, when the ultimate elongation is about 5%. Generally, larger the knuckle radius, stronger is the corner torus section of a head. The knuckle radius provided should be less than __________ of the head.
The ratio of lateral strain to linear strain is termed as the
Frame thickness in the plate and frame filter press is normally in the range of __________ inches.
In a shell and tube heat exchanger having square pitch, the shell side equivalent diameter is given by (where, P = pitch, d = outside diameter of the tube)
Filtration rate is affected by the
__________ heat exchanger is also known as 'hair pin type' exchanger,
Optimum economic pipe diameter for fluid flow is determined by the
Pick out the wrong statement pertaining to shell and tube heat exchanger.

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion