Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Home
»
Technical Drawing
»
Sectional Views
The section view drawing in which one fourth of an object has been marked for removal is known as a ________ section.
full
half
quarter
none of the above
Correct Answer:
half
← Previous Question
Next Question→
More Questions from
Sectional Views
Ribs, webs, gear teeth, and other similar features are typically not hatched with section lining, even if the cutting plane slices them.
When a cutting plane coincides with a centerline, the cutting plane line takes precedence.
Section views are only used for mechanical drawings.
The visible lines adjacent to a revolved section may be broken out if desired.
The pattern used for hatching a section can be something other than diagonal lines.
In technical drawing a section view is often used to reveal some or all of an object's internal features.
When a cutting plane line would obscure important details, just the ends of the line outside the view and the arrows can be shown.
It is not acceptable to use the general-purpose symbol at different angles for different parts.
In AutoCAD the Hatch tool is used to designate what pattern is to be used for a section view.
The Cutting Plane line should be displayed at the same line weight as object lines.
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments