Sectional Views problems
- 1. In this type of section, one quarter of the object is removed:
Options- A. Revolved section
- B. Removed section
- C. Quarter section
- D. Half section Discuss
Correct Answer: Half section
- 2. These breaks are used to shorten the view of an object:
Options- A. Section breaks
- B. Aligned breaks
- C. Conventional breaks
- D. Full breaks Discuss
Correct Answer: Conventional breaks
- 3. A ________ section allows the drafter to create a Cutting Plane line which is not in a straight line across the part.
Options- A. Offset
- B. half
- C. whole
- D. broken out Discuss
Correct Answer: Offset
- 4. This type of section is limited by a break line:
Options- A. Removed section
- B. Revolved section
- C. Broken-out section
- D. Half section Discuss
Correct Answer: Broken-out section
- 5. By using a ________ section of a cylindrical mechanical part the drafter should be able to show only one view of the part.
Options- A. half
- B. whole
- C. revolved
- D. broken out Discuss
Correct Answer: revolved
- 6. When only a small section of an interior area needs to be revealed the drafter can use a ________ section.
Options- A. half
- B. quarter
- C. full
- D. broken out Discuss
Correct Answer: broken out
- 7. The section view drawing in which one fourth of an object has been marked for removal is known as a ________ section.
Options- A. full
- B. half
- C. quarter
- D. none of the above Discuss
Correct Answer: half
- 8. Ribs, webs, gear teeth, and other similar features are typically not hatched with section lining, even if the cutting plane slices them.
Options- A. True
- B. False Discuss
Correct Answer: True
- 9. When a cutting plane coincides with a centerline, the cutting plane line takes precedence.
Options- A. True
- B. False Discuss
Correct Answer: True
- 10. Section views are only used for mechanical drawings.
Options- A. True
- B. False Discuss
Correct Answer: False
More in Technical Drawing:
Programming
Copyright ©CuriousTab. All rights reserved.