Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Home
»
Technical Drawing
»
Sectional Views
In offset sections, offsets or bends in the cutting plane are all:
90 degrees
180 degrees
Either 90 or 180 degrees
30, 60, or 90 degrees
Correct Answer:
90 degrees
← Previous Question
Next Question→
More Questions from
Sectional Views
In the section view, the areas that would have been in actual contact with the cutting plane are shown with:
When filling an area with a hatch pattern in AutoCAD the drafter needs to be able to ________.
Objects that are symmetric can be shown effectively using this type of section:
In this type of section, one quarter of the object is removed:
These breaks are used to shorten the view of an object:
A ________ section allows the drafter to create a Cutting Plane line which is not in a straight line across the part.
This type of section is limited by a break line:
By using a ________ section of a cylindrical mechanical part the drafter should be able to show only one view of the part.
When only a small section of an interior area needs to be revealed the drafter can use a ________ section.
The section view drawing in which one fourth of an object has been marked for removal is known as a ________ section.
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments