Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Home
»
Technical Drawing
»
Sectional Views
A ________ section allows the drafter to create a Cutting Plane line which is not in a straight line across the part.
Offset
half
whole
broken out
Correct Answer:
Offset
← Previous Question
Next Question→
More Questions from
Sectional Views
This type of section is limited by a break line:
By using a ________ section of a cylindrical mechanical part the drafter should be able to show only one view of the part.
When only a small section of an interior area needs to be revealed the drafter can use a ________ section.
The section view drawing in which one fourth of an object has been marked for removal is known as a ________ section.
Ribs, webs, gear teeth, and other similar features are typically not hatched with section lining, even if the cutting plane slices them.
When a cutting plane coincides with a centerline, the cutting plane line takes precedence.
Section views are only used for mechanical drawings.
The visible lines adjacent to a revolved section may be broken out if desired.
The pattern used for hatching a section can be something other than diagonal lines.
In technical drawing a section view is often used to reveal some or all of an object's internal features.
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments