Curioustab

Home » Technical Drawing » Sectional Views

By using a ________ section of a cylindrical mechanical part the drafter should be able to show only one view of the part.

half
whole
revolved
broken out

Correct Answer: revolved

← Previous Question Next Question→

More Questions from Sectional Views

When only a small section of an interior area needs to be revealed the drafter can use a ________ section.
The section view drawing in which one fourth of an object has been marked for removal is known as a ________ section.
Ribs, webs, gear teeth, and other similar features are typically not hatched with section lining, even if the cutting plane slices them.
When a cutting plane coincides with a centerline, the cutting plane line takes precedence.
Section views are only used for mechanical drawings.
The visible lines adjacent to a revolved section may be broken out if desired.
The pattern used for hatching a section can be something other than diagonal lines.
In technical drawing a section view is often used to reveal some or all of an object's internal features.
When a cutting plane line would obscure important details, just the ends of the line outside the view and the arrows can be shown.
It is not acceptable to use the general-purpose symbol at different angles for different parts.

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion