Auxiliary Views problems
- 1. The offset distance for the width (front to back) distance of the auxiliary view is the same distance of the ________ in the top view.
Options- A. Width
- B. height
- C. length
- D. none of the above Discuss
Correct Answer: Width
- 2. When using the descriptive geometry method to create an auxiliary view the drafter should ________.
Options- A. rotate the snap grid to the same angle of the inclined plane
- B. offset the right vertical line of the front view
- C. rotate the top line of the front view 45 degrees
- D. offset the top line of the front view 2 inches Discuss
Correct Answer: rotate the snap grid to the same angle of the inclined plane
- 3. This type of solid is formed by sweeping a shape along a linear path:
Options- A. Planar solid
- B. Revolved solid
- C. Warped solid
- D. Extruded solid Discuss
Correct Answer: Extruded solid
- 4. A secondary auxiliary view is a projection off of the ________.
Options- A. Front view
- B. Top view
- C. Primary auxiliary view
- D. None of the above Discuss
Correct Answer: Primary auxiliary view
- 5. When adding dimensions to an auxiliary view it will be necessary to use the ________ tool.
Options- A. Linear dimension
- B. Aligned dimension
- C. Baseline dimension
- D. Angle dimension Discuss
Correct Answer: Aligned dimension
- 6. In this type of auxiliary view, a break line is used to indicate the imaginary break in the views:
Options- A. Primary
- B. Secondary
- C. Revolved
- D. Partial Discuss
Correct Answer: Partial
- 7. Circular shapes appear in this fashion when viewed at an angle other than 90 degrees:
Options- A. Circular
- B. Elliptical
- C. Lengthened
- D. Angular Discuss
Correct Answer: Elliptical
- 8. A secondary view is always perpendicular to one of the principal views.
Options- A. True
- B. False Discuss
Correct Answer: False
- 9. Measurements are always made at right angles to the reference lines or parallel to the projection lines.
Options- A. True
- B. False Discuss
Correct Answer: True
- 10. A Secondary Auxiliary view is a projection from the first auxiliary view.
Options- A. True
- B. False Discuss
Correct Answer: True
More in Technical Drawing:
Programming
Copyright ©CuriousTab. All rights reserved.