Isometric Drawings problems
- 1. Architectural drafters generally prefer to use ________ drawings to help illustrate 3-dimensional views of a structure.
Options- A. isometric
- B. perspective
- C. orthographic
- D. auxiliary Discuss
Correct Answer: perspective
- 2. The Offset tool should only be used for placing ________ in an isometric drawing.
Options- A. circles
- B. horizontal lines
- C. vertical lines
- D. none of the above Discuss
Correct Answer: vertical lines
- 3. A round is a rounded surface on the ________ corner of a part.
Options- A. inside
- B. outside
- C. radial
- D. isoplane Discuss
Correct Answer: outside
- 4. AutoCAD refers to isometric ellipses as ________.
Options- A. Ellipses
- B. isoellipses
- C. isocircles
- D. circles Discuss
Correct Answer: isocircles
- 5. Isometric drawings are often used by ________ to help illustrate complex designs.
Options- A. mechanical engineers
- B. piping drafters
- C. aerospace engineers
- D. all of the above Discuss
Correct Answer: all of the above
- 6. In order to create an isometric circle to represent a hole through the top surface of a box, the drafter must insure that the correct isoplane has been selected by scrolling through the isoplanes using the ________ key.
Options- A. F1
- B. F3
- C. F5
- D. F8 Discuss
Correct Answer: F5
- 7. The bounding box method for setting up an isometric drawing helps the drafter ________.
Options- A. confine the isometric drawing to its maximum size
- B. figure what lines are to be illustrated vertical and horizontal
- C. position the isometric drawing in paper space
- D. none of the above Discuss
Correct Answer: confine the isometric drawing to its maximum size
- 8. When creating an isometric drawing in AutoCAD the drafter can utilize the Dynamic Input and Polar Coordinate system to place both vertical and horizontal lines. A line created from one point 3 inches at 180 degrees would be a ________ line.
Options- A. horizontal
- B. vertical
- C. inclined
- D. none of the above Discuss
Correct Answer: vertical
- 9. A fillet is a rounded surface on the ________ corner of a part.
Options- A. Inside
- B. outside
- C. radial
- D. isoplane Discuss
Correct Answer: Inside
- 10. Before starting an isometric drawing in AutoCAD the drafter needs to ________.
Options- A. set the grid to isometric
- B. set the current layer to Defpoints
- C. turn Object Snap off
- D. turn Ortho off Discuss
Correct Answer: set the grid to isometric
More in Technical Drawing:
Programming
Copyright ©CuriousTab. All rights reserved.