Oblique Projection problems
- 1. Oblique drawings are dimensioned in a similar fashion as these types of drawings:
Options- A. Orthographic
- B. Isometric
- C. Angular
- D. Parallel Discuss
Correct Answer: Isometric
- 2. In a CAD system, you can draw an ellipse by specifying these:
Options- A. The bounding lines
- B. The midpoint and end points
- C. The center and major and minor axes
- D. The center and radius Discuss
Correct Answer: The center and major and minor axes
- 3. When the receding lines are true length, and the projectors are at 45 degrees to the plane of projection, the oblique drawing is called this:
Options- A. Cabinet projection
- B. Cavalier projection
- C. Axonometric projection
- D. Isometric projection Discuss
Correct Answer: Cavalier projection
- 4. Oblique sections are useful to show this:
Options- A. Foreshortened features
- B. Oblique lines
- C. Interior shapes
- D. Projected features Discuss
Correct Answer: Interior shapes
- 5. In oblique projection, important shapes should be in this position relative to the viewing plane:
Options- A. Parallel
- B. Perpendicular
- C. Adjacent
- D. Rotated Discuss
Correct Answer: Parallel
- 6. In an oblique drawing, equally spaced partial circles may be used to show this:
Options- A. Symbolic thread pitch
- B. Ellipses
- C. Cavalier drawings
- D. Projection points Discuss
Correct Answer: Symbolic thread pitch
- 7. If you are sketching an ellipse in an oblique drawing, you can block in the enclosing rectangle and sketch the ellipse tangent to its sides.
Options- A. True
- B. False Discuss
Correct Answer: True
- 8. In general, all types of sections for isometric drawing may be applied to oblique drawing.
Options- A. True
- B. False Discuss
Correct Answer: True
- 9. If a complicated pictorial is needed, it may be easier and more accurate to create a 3D model than an oblique drawing.
Options- A. True
- B. False Discuss
Correct Answer: True
- 10. In an oblique drawing, when an angle is specified in degrees in a receding plane, you should convert the angle into circular measurements.
Options- A. True
- B. False Discuss
Correct Answer: False
More in Technical Drawing:
Programming
Copyright ©CuriousTab. All rights reserved.