Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Home
»
Networking
»
Networking Basics
What command will display the line, protocol, DLCI, and LMI information of an interface?
sh pvc
show interface
show frame-relay pvc
show run
Correct Answer:
show interface
Explanation:
The
show interface
command shows the line, protocol, DLCI, and LMI information of an interface.
← Previous Question
Next Question→
More Questions from
Networking Basics
What is a stub network?
You have 10 users plugged into a hub running 10Mbps half-duplex. There is a server connected to the switch running 10Mbps half-duplex as well. How much bandwidth does each host have to the server?
What does a VLAN do?
What protocols are used to configure trunking on a switch? VLAN Trunking Protocol VLAN 802.1Q ISL
Which of the following is the valid host range for the subnet on which the IP address 192.168.168.188 255.255.255.192 resides?
Which protocol is used to send a destination network unknown message back to originating hosts?
What does the passive command provide to dynamic routing protocols?
Which protocol does DHCP use at the Transport layer?
Which router command allows you to view the entire contents of all access lists?
Which command is used to determine if an IP access list is enabled on a particular interface?
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments