Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Home
»
Networking
»
Networking Basics
What command is used to create a backup configuration?
copy running backup
copy running-config startup-config
config mem
wr mem
Correct Answer:
copy running-config startup-config
Explanation:
The command to back up the configuration on a router is
copy running-config startup-config
.
← Previous Question
Next Question→
More Questions from
Networking Basics
If your router is facilitating a CSU/DSU, which of the following commands do you need to use to provide the router with a 64000bps serial link?
In a network with dozens of switches, how many root bridges would you have?
What command will display the line, protocol, DLCI, and LMI information of an interface?
What is a stub network?
You have 10 users plugged into a hub running 10Mbps half-duplex. There is a server connected to the switch running 10Mbps half-duplex as well. How much bandwidth does each host have to the server?
What does a VLAN do?
What protocols are used to configure trunking on a switch? VLAN Trunking Protocol VLAN 802.1Q ISL
Which of the following is the valid host range for the subnet on which the IP address 192.168.168.188 255.255.255.192 resides?
Which protocol is used to send a destination network unknown message back to originating hosts?
What does the passive command provide to dynamic routing protocols?
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments