Gears can be best produced on mass production by

More Questions from Production Engineering

• Gears can be cut on a shaper.
• Jigs are used
• The hole to be drilled for tapping is __________ the outside diameter of the thread on the tap.
• Dielectric is used in
• The size of a lathe is specified by the
• A drill mainly used in drilling brass, copper or softer materials, is
• Flank wear occurs mainly on the
• The hole drilled for tapping should be smaller than the tap size by twice the depth of thread.
• Which of the following statement is wrong?
• Slow speed of the spindle is necessary in

Discussion & Comments