Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Home
»
Mechanical Engineering
»
Production Engineering
Ceramic cutting tools are
made by cold pressing of aluminium oxide powder
available in the form of tips
brittle and have low bending strength
all of these
Correct Answer:
all of these
← Previous Question
Next Question→
More Questions from
Production Engineering
Spot facing is an operation of smoothing and squaring the surface around a hole.
The tail stock and the carriage of a lathe may be guided on same or different guideway.
In __________ operation, the chip thickness is minimum at the beginning of the cut and it reaches to the maximum when the cut terminates.
In centreless grinders, the regulating wheel is inclined at
The average cutting speed for turning mild steel with a high speed steel tool is
A drill bit of 20 mm diameter rotating at 500 r.p.m. with a feed rate of 0.2 mm/revolution is used to drill a through-hole in a mild steel plate 20 mm thickness. The depth of cut in this drilling operation is
The taper on the lathe spindle is
The tool life is __________ cutting speed.
The aluminium oxide abrasive is chiefly used for grinding
In metal machining, the zone where the maximum heat is generated due to the plastic deformation of metal, is called
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments