Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Home
»
Mechanical Engineering
»
Production Engineering
A bottoming tap has
its end tapered for about three or four threads
its end tapered for about eight or ten threads
full threads for the whole of its length
none of the above
Correct Answer:
full threads for the whole of its length
← Previous Question
Next Question→
More Questions from
Production Engineering
The cutting speed for drilling __________ with high speed steel drills is 24 to 45 m/min.
A fine grained grinding wheel is used to grind
Hard and tough materials like cast iron should be turned at
Tumbler gears in lathe are used to
In the relation VTn = C, the value of n for high speed steel tools varies from 0.25 to 0.40.
Negative rakes are used for
In oblique cutting system, the cutting edge of the tool
Flank wear is due to the abrasive action of hard mis-constituents including debris from built up edge as the work material rubs the work surface.
In gear hobbing
A numerical method of identification of tool is known as tool signature.
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments