Curioustab

Home » Electronics » Analog and Digital Converters

Which is not an analog-to-digital (ADC) conversion error?

differential nonlinearity
missing code
incorrect code
offset

Correct Answer: differential nonlinearity

← Previous Question Next Question→

More Questions from Analog and Digital Converters

Sample-and-hold circuits in analog-to digital converters (ADCs) are designed to:
In a flash analog-to-digital converter, the output of each comparator is connected to an input of a:
Incorrect codes are a form of output error for a digital-to-analog converter (DAC).
The key advantage of the successive approximation analog-to-digital converter (ADC) is its conversion speed.
In a binary-weighted digital-to-analog converter (DAC), the values of the input resistors are chosen to be proportional to the binary weights of the corresponding input bits.
A sample-and-hold circuit samples an analog value and holds it long enough for the analog-to-digital conversion to occur.
The relative accuracy of a digital-to-analog converter (DAC) is determined by settling time.
One way to determine the resolution of a digital-to-analog converter (DAC) is to compare the ratio of one step voltage to the maximum output voltage.
The flash method of analog-to-digital conversion (ADC) uses comparators that compare reference voltages with the analog input voltage.
An 8-bit digital-to-analog converter (DAC) has a resolution of 0.125 V.

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion