Home » Electronics and Communication Engineering » Matching Questions

Match the following: List I List II A. Total instantaneous value of emitter current 1. IE B. Quiescent value of emitter current 2. iE C. Instantaneous value of as component of emitter current 3. Ie D. RMS value of ac component of emitter current 4. ie

A-1, B-2, C-4, D-3
A-2, B-1, C-4, D-3
A-2, B-1, C-3, D-4
A-2, B-3, C-4, D-1

Correct Answer: A-2, B-1, C-4, D-3

← Previous Question Next Question→

More Questions from Matching Questions

Match the following: List I (Component) List II (Dominant TE mode) A. Rectangular wave guide 1. TE101 B. Circular waveguide 2. TE10 C. Rectangular cavity 3. TE111 4. TE11
Match the following: List I List II A. T (Reflection coefficient) = 0 1. (ZL - Zo)/(ZL + Zo) B. T = - 1 2. ZL = Zo C. T = + 1 3. ZL = 0 D. - 1 < T < + 1 4. ZL = ∞
Match the following: List I List II A. AM-DSB FC 1. 2 B. WBFM 2. 1 C. PCM 3. 3m D. AM-DSB 4. 22N
List I (Parameters) List II (Values) A. h22 1. rb + re B. h11 2. acb C. h21 3.
Match the following: List I List II A. IF noise 1. Ganged tuning B. Image frequency 2. Spurious response C. Station selector 3. Leaky filter capacitor D. Excessive Hum 4. Mixer stage
Match the following: List I (Diode circuit) List II (Name of the circuit) A. 1. Positive limiter B. 2. Positive clamper C. 3. Negative clamper
Match the following: List I (Modes) List II (Characteristic) A. Evanescent 1. Rectangular waveguide does not support B. Dominant mode 2. No wave propagation C. TM10 and TM01 3. Lowest cut-off frequency
Match the following: List I List II A. D Layer 1. 110 km B. E layer 2. 10 km C. F layer 3. 60 km D. Troposphere 4. 350 km
Match the following: List I List II A. loop antenna 1. flat line B. folded dipole 2. 300 W C. SWR of 1 3. sharp broadside full D. VHF band 4. 30 to 300 MHz
Match the following: List I (Devices) List II (characteristic) A. BJT 1. Voltage controlled negative resistance B. MOSFET 2. High current gain C. Tunnel diode 3. Voltage regulation D. Zener diode 4. High input impedance

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion