Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Home
»
Electronics and Communication Engineering
»
Analog Electronics
The output V0 in figure is
-100 V
-100 mV
10 V
10 mV
Correct Answer:
-100 mV
Explanation:
Input to non-inverting op-amp is -10 x 10
-6
x 10
3
= -10 mV.
Therefore output =
= -100 mV.
← Previous Question
Next Question→
More Questions from
Analog Electronics
DC amplifiers have a tendency to be unstable.
Study the circuit of figure and examine the following statements It is an active low pass finer. It is a second order filter. The change in gain is 40 dB/decade. Which of the above statements are correct?
The 'h' parameters of the circuit shown in the figure are hib = 25 Ω, hfb = 0.999 and hob = 10-6Ω The Voltage gain is
A forward voltage of 9 V is applied to a diode in series with a 1 kΩ load resistor. The voltage across load resistor is zero. It indicates that
To prevent a DC return between source and load, it is necessary to use
The self bias provides
The quiescent collector current IC, and collector to emitter voltage VCE in a CE connection are the values when
Figure shows the self bias circuit for CE amplifier and its equivalent circuit. VBB and RB respectively are
In a circuit of figure, Vs = 10 cos(ωt) power drawn by the 2Ω resistor is 4 watts. The power factor is
In a BJT circuit a pnp transistor is replaced by npn transistor. To analyse the new circuit
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments