Curioustab

Home » Electronics and Communication Engineering » Analog Electronics

The 'h' parameters of the circuit shown in the figure are hib = 25 Ω, hfb = 0.999 and hob = 10-6Ω The Voltage gain is

0.99
1.98
2.0
4

Correct Answer: 4

Explanation:

Z_i = 25 + 10^-6 x 0.99 x 10⁴ ⟹ 25

.

← Previous Question Next Question→

More Questions from Analog Electronics

A forward voltage of 9 V is applied to a diode in series with a 1 kΩ load resistor. The voltage across load resistor is zero. It indicates that
To prevent a DC return between source and load, it is necessary to use
The self bias provides
The quiescent collector current IC, and collector to emitter voltage VCE in a CE connection are the values when
Figure shows the self bias circuit for CE amplifier and its equivalent circuit. VBB and RB respectively are
In a circuit of figure, Vs = 10 cos(ωt) power drawn by the 2Ω resistor is 4 watts. The power factor is
In a BJT circuit a pnp transistor is replaced by npn transistor. To analyse the new circuit
An amplifier has a large ac input signal. The clipping occurs on both the peaks. The output voltage will be nearly a
If an amplifier with gain of - 1000 and feedback factor β = - 0.1 had a gain change of 20% due to temperature, the change in gain of the feedback amplifier would be
In the op-amp circuit of figure, V0 =

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion