Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Home
»
Electronics and Communication Engineering
»
Analog Electronics
In a BJT circuit a pnp transistor is replaced by npn transistor. To analyse the new circuit
all calculations done earlier have to be repeated
replace all calculated voltages by reverse values
replace all calculated currents by reverse values
replace all calculated voltages and currents by reverse values
Correct Answer:
replace all calculated voltages and currents by reverse values
Explanation:
All voltages and currents have reverse polarity.
← Previous Question
Next Question→
More Questions from
Analog Electronics
An amplifier has a large ac input signal. The clipping occurs on both the peaks. The output voltage will be nearly a
If an amplifier with gain of - 1000 and feedback factor β = - 0.1 had a gain change of 20% due to temperature, the change in gain of the feedback amplifier would be
In the op-amp circuit of figure, V0 =
To protect the diodes in a rectifier and capacitor input filter circuit it is necessary to use
In figure v1 = 8 V and v2 = 4 V. Which diode will conduct?
In figure ID = 4 mA. Then VS =
A half wave diode rectifier has a capacitance input filter. If input voltage is Vm sin ωt, PIV is
The efficiency of a full wave rectifier using centre tapped transformer is twice that in full wave bridge rectifier.
The transistor of following figure in Si diode with a base current of 40 μA and ICBO = 0, if VBB = 6V, RE = 2 kΩ and β = 90, IBQ = 20 μA then RB =
If the input to the ideal comparator shown in the figure is a sinusoidal signal of 8 V (peak to peak) without any DC component, then the output of the comparator has a duty cycle of
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments