Discussion
Home ‣ Technical Drawing ‣ Dimensioning Architectural Drawings Comments
- Question
Text and dimensions are aligned on the drawing so they can be easily read from the bottom and right side of the sheet.
Options- A. True
- B. False
- Correct Answer
- True
- 1. Manufacturing involves making products from raw materials.
Options- A. True
- B. False Discuss
- 2. In net-shape manufacturing, the part is made as close to the final specifications as possible to cut down on the cost of finishing operations.
Options- A. True
- B. False Discuss
- 3. Rapid prototyping costs about the same, but takes less time than traditional prototyping.
Options- A. True
- B. False Discuss
- 4. Concurrent engineering involves all disciplines in the early design stages.
Options- A. True
- B. False Discuss
- 5. Solid ground curing systems are the most common rapid prototyping systems.
Options- A. True
- B. False Discuss
- 6. The dimensioning standards used by a typical architectural firm were probably developed by the architects, designers, and drafters in the firm.
Options- A. True
- B. False Discuss
- 7. Architectural drafters are usually expected to place dimensions to the CAD standards established by the firm.
Options- A. True
- B. False Discuss
- 8. The total dimension of the front side should match the total dimension of the back side.
Options- A. True
- B. False Discuss
- 9. Dimensioning to the edges of doors and windows is the preferred method by most architectural drafters.
Options- A. True
- B. False Discuss
- 10. Drafters usually begin a set of dimensions from the inside edge of an exterior wall.
Options- A. True
- B. False Discuss
Dimensioning Architectural Drawings problems
Search Results
Correct Answer: True
Correct Answer: True
Correct Answer: False
Correct Answer: True
Correct Answer: False
Correct Answer: True
Correct Answer: True
Correct Answer: True
Correct Answer: False
Correct Answer: False
Comments
There are no comments.More in Technical Drawing:
Programming
Copyright ©CuriousTab. All rights reserved.