logo

CuriousTab

CuriousTab

Discussion


Home Technical Drawing Tolerancing Comments

  • Question
  • Tolerances of form and position are typically not used to control straightness.


  • Options
  • A. True
  • B. False

  • Correct Answer
  • False 


  • Tolerancing problems


    Search Results


    • 1. Nominal size is used for general identification and is usually expressed in decimals.

    • Options
    • A. True
    • B. False
    • Discuss
    • 2. Implied 90 degree angles typically have different general tolerances applied to them than other angles covered by a general note.

    • Options
    • A. True
    • B. False
    • Discuss
    • 3. Allowance is the maximum clearance or minimum interference specified to achieve a fit between two mating parts.

    • Options
    • A. True
    • B. False
    • Discuss
    • 4. Unilateral tolerances have traditionally been given on angles.

    • Options
    • A. True
    • B. False
    • Discuss
    • 5. A heavy straight line should be drawn under all dimension values that are to scale.

    • Options
    • A. True
    • B. False
    • Discuss
    • 6. Defining the datum reference frame is necessary to apply GDT principles.

    • Options
    • A. True
    • B. False
    • Discuss
    • 7. Datum surfaces and features are used as references to control other features.

    • Options
    • A. True
    • B. False
    • Discuss
    • 8. Geometric dimensioning and tolerancing can simplify the inspection process.

    • Options
    • A. True
    • B. False
    • Discuss
    • 9. Specific tolerances are based on the part's function and fit.

    • Options
    • A. True
    • B. False
    • Discuss
    • 10. Tolerance is the total amount a specific dimension is permitted to vary.

    • Options
    • A. True
    • B. False
    • Discuss


    Comments

    There are no comments.

Enter a new Comment