Discussion
Home ‣ Technical Drawing ‣ Sectional Views Comments
- Question
Section views are only used for mechanical drawings.
Options- A. True
- B. False
- Correct Answer
- False
- 1. When a cutting plane coincides with a centerline, the cutting plane line takes precedence.
Options- A. True
- B. False Discuss
- 2. Ribs, webs, gear teeth, and other similar features are typically not hatched with section lining, even if the cutting plane slices them.
Options- A. True
- B. False Discuss
- 3. Visible lines always take precedence over hidden lines or centerlines.
Options- A. True
- B. False Discuss
- 4. Width is shown in the rear, top, front, and bottom views.
Options- A. True
- B. False Discuss
- 5. Any object can be viewed from six mutually perpendicular views.
Options- A. True
- B. False Discuss
- 6. The visible lines adjacent to a revolved section may be broken out if desired.
Options- A. True
- B. False Discuss
- 7. The pattern used for hatching a section can be something other than diagonal lines.
Options- A. True
- B. False Discuss
- 8. In technical drawing a section view is often used to reveal some or all of an object's internal features.
Options- A. True
- B. False Discuss
- 9. When a cutting plane line would obscure important details, just the ends of the line outside the view and the arrows can be shown.
Options- A. True
- B. False Discuss
- 10. It is not acceptable to use the general-purpose symbol at different angles for different parts.
Options- A. True
- B. False Discuss
Sectional Views problems
Search Results
Correct Answer: True
Correct Answer: True
Correct Answer: True
Correct Answer: True
Correct Answer: True
Correct Answer: True
Correct Answer: True
Correct Answer: True
Correct Answer: True
Correct Answer: False
Comments
There are no comments.More in Technical Drawing:
Programming
Copyright ©CuriousTab. All rights reserved.