logo

CuriousTab

CuriousTab

Discussion

Home ‣ Technical Drawing ‣ Dimensioning Comments
  • Question

  • Most mechanical drawings will include tolerance information in or near the drawing title block.


  • Options
  • A. True
  • B. False

  • Correct Answer
  • True 

    • Dimensioning problems

    Search Results

    • 1. Avoid dimensioning to hidden lines.

    • Options
    • A. True
    • B. False
      • Discuss
    • 2. Longer dimension lines are nearest the object outline.

    • Options
    • A. True
    • B. False
      • Discuss
    • 3. It is more difficult to manufacture a part designed using two decimal places than the same part using four decimal places.

    • Options
    • A. True
    • B. False
      • Discuss
    • 4. The inch is the commonly used unit for most metric engineering drawings.

    • Options
    • A. True
    • B. False
      • Discuss
    • 5. Where the decimal-inch dimension is used, a zero is not used before the decimal point of values less than 1.

    • Options
    • A. True
    • B. False
      • Discuss
    • 6. Typically, all dimension values and notes are lettered horizontally and should read from the bottom of the sheet.

    • Options
    • A. True
    • B. False
      • Discuss
    • 7. A set of two mutually perpendicular datum planes is required for coordinate dimensioning.

    • Options
    • A. True
    • B. False
      • Discuss
    • 8. When a finished part is measured, it may vary slightly from the exact dimension specified.

    • Options
    • A. True
    • B. False
      • Discuss
    • 9. The American Society of Mechanical Engineers provides a set of common standards used by industry for placement of dimensions.

    • Options
    • A. True
    • B. False
      • Discuss
    • 10. Fillet radii can be given in a general note.

    • Options
    • A. True
    • B. False
      • Discuss

    Comments

    There are no comments.
Enter a new Comment




Aptitude

Engineering

Programming

Reasoning

Links

Copyright ©CuriousTab. All rights reserved.