Discussion
Home ‣ Technical Drawing ‣ Orthographic Projection Comments
- Question
Usually screws, bolts, shafts, tubes, and other elongated parts are drawn in a vertical position in the front view.
Options- A. True
- B. False
- Correct Answer
- False
- 1. A plane surface that is parallel to a plane of projection appears on edge as a straight line.
Options- A. True
- B. False Discuss
- 2. The profile plane is the plane upon which the side view is projected.
Options- A. True
- B. False Discuss
- 3. In orthographic views, dashed lines represent features that would be hidden behind other surfaces.
Options- A. True
- B. False Discuss
- 4. Orthographic projections have projectors that are parallel to the plane of projection.
Options- A. True
- B. False Discuss
- 5. Scale is stated as a ratio of the number of drawing units to the number of actual units.
Options- A. True
- B. False Discuss
- 6. If an edge is perpendicular to a plane of projection, it appears as a point.
Options- A. True
- B. False Discuss
- 7. The depth dimensions in the top and side views do not necessarily correspond.
Options- A. True
- B. False Discuss
- 8. If an angle is in an inclined plane, it may be projected either larger or smaller than the true angle depending on its position.
Options- A. True
- B. False Discuss
- 9. A plane surface always projects either on edge or as a surface in any view.
Options- A. True
- B. False Discuss
- 10. Any principal view shows three of the four principal dimensions.
Options- A. True
- B. False Discuss
Orthographic Projection problems
Search Results
Correct Answer: False
Correct Answer: True
Correct Answer: True
Correct Answer: False
Correct Answer: True
Correct Answer: True
Correct Answer: False
Correct Answer: True
Correct Answer: True
Correct Answer: False
Comments
There are no comments.More in Technical Drawing:
Programming
Copyright ©CuriousTab. All rights reserved.