Curioustab

Home » Civil Engineering » Surveying

Rankine's deflection angle in minutes is obtained by multiplying the length of the chord by

degree of the curve
square of the degree of the curve
inverse of the degree of the curve
none of these.

Correct Answer: degree of the curve

← Previous Question Next Question→

More Questions from Surveying

The chaining on sloping ground is
Subtense tacheometry is generally preferred to if ground is
The conventional sign shown in below figure represents a
If L is the specified length of a tape, L1 its actual length and S the measured distance, then, the true distance is given by the formula,
You have to observe an included angle with better accuracy than what is achievable by a vernier, you will prefer the method of
Accidental or compensating errors of length L are proportional to
If a linear traverse follows a sharp curve round a large lake where it is difficult to have long legs, the accuracy of the traverse may be improved by
The operation of resection involves the following steps rough orientation of the plane table the three lines form a triangle of error drawing lines back through the three control points select a point in the triangle of error such that each ray is equally rotated either clockwise or anti clockwise the points obtained by three rays is the correct location. The correct sequence is
Pick up the correct statement from the following
Check lines (or proof lines) in Chain Surveying, are essentially required

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion